Subject: Re: new output variables
From: Erik Kluzek (erik@ncar.ucar.edu)
Date: Fri Dec 03 1999 - 14:42:05 MST
On Thu, 2 Dec 1999, Govindasamy Balasubramanian wrote:
>
> I need to output a few variables I defined (like longwave flux at the
> tropopause FLNTT) in tphysbc.F.
>
> If I define these variables in bldfld.F (call addfld('FLNTT5 ','W/M2
> ',nf,nsingl,active))
> and callthe routine outfld ( call outfld('FLNTT5 ',flntt5 ,plond,lat,hbuf))
> for these variables in tphysbc.F , will it work smoothly?
>
Yes this is all you need to do. Assuming of course that flntt4 is properly
dimensioned and contains valid data...
The following web-page go into some explaination on adding fields to output files.
In the Online CCM3 Users Guide (Section 4.2)...
http://www.cgd.ucar.edu/cms/ccm3/ccm3lsm_doc/ccm3_doc/UG-103.html
Erik Kluzek, (CGD at NCAR)
National Center for Atmospheric Research
Boulder CO, (off) (303)497-1326 (fax) (303)497-1324
--------- Home page and public PGP key---------------
http://www.cgd.ucar.edu/~erik
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
This archive was generated by hypermail 2b27 : Thu Jun 01 2000 - 09:29:02 MDT